Oyun Listesi
  • Mart 17, 2021
  • Ekleyen
In daily work, embroidery machines will inevitably fail and cause damage to embroidery machine accessories, but most of them are caused by lack of operation or experience. Today we will briefly explain the common problems and solutions during the operation of embroidery machines.
(1) When all the pins are in the high position, the dial cannot be turned by hand;
(2) Do not jog when the pin is in the high position, otherwise it is easy to get stuck;
(3) Make preparations before driving the lever, wear the bottom thread, choose the pattern to be embroidered, choose the working method that matches the pattern and the appropriate embroidery parameters;
(4) Before driving the lever, check whether all the pins are put down. If not, put all the pins down manually, and then pull the lever to drive, otherwise it is easy to cause damage to the machine or leaking flowers;
(5) When embroidering sequins, the switch of the sequin device should be set to the upper position, otherwise the sequin device will not automatically rise and fall;
(6) The air pressure of the sequin device should be appropriate, too small to be unable to lift automatically, and too large to break the sequin device. After adjusting the air pressure, do not adjust it casually;
(7) Every time a new three-in-one combination pattern is made, the frame check should be done after setting the embroidering point, so as to prevent the frame from overshooting when the left and right machine heads are switched, and the sequin device or machine head will be damaged;
(8) When taping embroidery and zigzag embroidery repairing, you should first loosen the upper thread on all the machine heads and the taping on the reel, and at the same time raise all the pins to the high position, and put the manipulator in the non-working state. , And then reverse the car, otherwise the fabric may be torn. After finishing the mending and embroidering, first arrange all the tapes on the reels, put down the pins, install the manipulator to the working position, and then pull the rod to drive;
(9) When embroidering a piece of embroidery, after pressing the piece of an embroidery function key, you should loosen all the cloth clamps before moving the embroidery frame, otherwise the fabric will be easily torn. When clamping the cloth after changing the frame, first clamp the front fabric, press the jog button, let the needles and pins leave the fabric, and then clamp the backcloth clamp, so that the clamped fabric is relatively flat;
(10) After each pattern is embroidered, all the cloth clips must be placed on the two corners of the front of the table when removing the cloth clips. They cannot be placed on the wire rack or behind the table to prevent the cloth from being clipped on the fabric. Or fall into the gap of the platen connecting plate, causing damage to the cloth surface or the machine.
Zhuji Zhiyu Machinery Co., Ltd. specializes in the production of embroidery machines and embroidery machine spare parts. We can provide you with the type of embroidery machine you need. If you need it, please contact us: https://www.zhiyuembroiderymachine.com/product/mac...